- Seal Lengths Available: 14", 20",
24", 30", 36", 48", 60",
72", 84", 96", 108" &
120" (custom lengths & configurations
available upon request).
- Seal Widths Available: 1/8", 3/16",
1/4", 3/8" & 1/2" (custom
widths & configurations available upon request).
- Water-Cooled or non Water-Cooled Heater
Bar.
- Heater Bar & Pressure Bar equipped with
our easy-to-replace Teflon.
- Hammertone Grey or FDA Compliant
White powder coated finish.
- All Stainless Steel Fasteners.
- Maintenance-Free Greaseless Needle Bearings.
- Trim Seal option available.
- PLC Time Control* or Temperature Control**
System.
- User Programmable Heat Time & Cool
Time*/Low Temp & High Temp** set points.
- Measures Temperature in the actual process
area on Heater Bar(s)**
- Operator Burn Protection - Ensures
that the heated parts of the machine are not
accessible to the operator until the low temperature
set point is reached.**
- Ensures that the melt temperature of the
material is reached on every cycle (accurate
to within approx. 5 Degrees Fahrenheit).**
|
- User-adjustable Software Rheostat allows
the operator to program the rate of temperature
rise.
- Runaway Heat Protection (shuts down
all system controls if the temperature exceeds
the setpoint by 100 Degrees Fahrenheit).
- 24VDC Control Circuitry.
- 2-Line x 20-Character Operator Interface.
- Text Error Messaging.
- Numeric Keypad Input.
- LED Indicator Lights.
- 50mm Emergency Stop.
- Cycle Counter (up to 99999-resetable).
- Cycle Timer (displays Cycle Time in
tenths of a second).
- Operates on Main Power Output of 120VAC
50/60Hz (220VAC available).
- Voltage Control (maintains constant
output to the heater element during low/high
voltage episodes.
- Proximity Switch Sensing.
- Obstruction Detection (opens sealing
jaws before going to high pressure if obstruction
is detected).
- Pressure Sensor - ensures that income
line pressure is adequate before allowing the
operator to begin the sealing process(optional
add-on).
- Pneumatic Air Cylinder.
- Two-Stage Remote Footswitch to activate
Vacuum/Seal Cycle.
- On/Off Vacuum - Retracts snorkels and
shuts off vacuum so that it can be used as a
regular heat sealer.
|
